Mute them (Preamp: -100dB) all except one to identify them. Then, using this test sound identify channels as seen by EqAPO, YouTube Then you see hat name gives EqAPO to the channels ( in my case "Channel: L" "Channel: SUB" etcetera, with other USB card the names were different. The simplest way is to just do some random settings using EqAPO GUI, add all channels to do a Low pass whatever, and then open the config.txt file. Yes, 1, 3, 5,7 are Right clones, and 2,4,6,8 Left clones.ĥ=-1*L means polarity inverted (180degrees), I used it for Le Cleach crossover type. I cannot make head or tails of those lines in this thread so far.Ĭopy: 1=R 2=L 3=L 4=R 5=-1*L 6=-1*R 7=L 8=R.ĭoes this mean outputs 1,5,1*7,8, are all derived from the original Right channel? idem 2,3,5,7 for Left?" "And how do you gentlemen assign the different channels to the soundcard outputs? "Is the 125lr4Sub_minphase44.wav the filename of a Rephase generated file?" What is the meaning of thee lines below in your config file? I could not trace that back to the Eq. #Midbass Right, Center output, Main Input Y #Midbass Left, Center output, Main Input Y One example from me, I do different the copy of channels.Ĭopy: 1=R 2=L 3=L 4=R 5=-1*L 6=-1*R 7=L 8=R Heres the config but theres some extra stuff in there that you don't need (i use it to test the channels) You need more than one receiver because basically almost none of them can amplify two different signals at the same time. (Stereo 1/8" jacks to RCA is the connectors you probably need). You should be using your PC as the source, and then the analog outputs from the soundcard connected to the analog inputs on the two amps. Its digital and won't transmit the signal properly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |